If you want your tension shower curtain rod to stay in place during the entire use of your shower, you’ll want to make sure the rod doesn’t move around at all. Of course, you could put a rubber cap on each end of the rod, but that gets old pretty quickly since you have to remove it every time you take down or rehang your shower curtain. Alternatively, if you have either two-part epoxy or contact cement, you can make sure your shower curtain rod stays exactly where it needs to be by gluing rubber shelf lining material onto the ends of the tension rods.
Benefits Of Using Rubber
A coated drapery rod can be longer than one without rubber lining and it will not rust, making it a better choice for bathrooms. 1 Apr 2020 The material is also less likely to fall off because of its thickness. 1 Apr 2020 Rubber lining is an inexpensive way to add a strong gripping surface to the ends of your shower curtain rod so that it does not easily slide down. 1 Apr 2020 If you want to prolong its life, even more, duschdraperistång vinkel furniture felt tape which will hold even better than silicone. 1 Apr 2020 On a final note, aside from shower curtains use heavy-duty rubber shelf liner as backing on closet rods and tension rods in apartments and dorms where walls are made from painted drywall rather than concrete block or brick.
How To Use Rubber
Unlike traditional shower rods that are made of plastic, rubber shower curtain rods are made from flexible materials. This makes them incredibly easy to work with. Using a sharp razor blade, cut two strips of rubber shelf lining material. Clean both sides of each rod and press one strip on each side of the front-facing end of your tension rod. Keep in mind that you will have to wash and dry your duschdraperistång badkar before hanging it; make sure it is wrinkle-free before you apply or you might risk damaging your rod with tugs and pulls! One final tip: If you use strong glue – such as epoxy or contact cement – instead of rubber strips, it may be necessary to let them sit for an hour or so after applying glue before putting up your curtain.
How To Cut And Install Rubber Coating
Cut a length of rubber-coated shower curtain rod material just long enough to reach from your shower wall to the outside edge of your shower curtain. Use a utility knife or razor blade to cut it and then use contact cement, or 2-part epoxy, to glue it in place on both ends of your tension rod.
If you have an old replacement tension rod that’s missing these caps, you can buy new ones online in most finishes. After applying any adhesives and using needle nose pliers (or channel locks) to hold them while they dry, make sure you check on them periodically over a 24-hour period because they’ll get quite hot as they cure.
Read more: How to Decorate Your Indoor Balcony with a Trolley
